Electrical service
Electrical troubleshooting and repair in Malden, MA
An outlet that stopped working, a breaker that will not stay on, lights that flicker. I find the cause first, explain it in plain words and then repair it.
- Fully insured
- Malden, MA and towns within 50 miles
Most electrical faults leave clues: a breaker that trips when the microwave and the toaster run together, an outlet that feels warm, a light that dims when the dryer starts. I start by asking what you noticed and when, then I test the circuit with a meter instead of guessing.
Once I know the cause, I tell you what it is and what the repair involves before I do it. Sometimes it is a loose connection or a worn outlet. Sometimes the circuit is carrying more than it was built for and needs a different answer.
What is included
- Dead outlets and switchesI trace the circuit to find where the power stops: a tripped GFCI, a loose connection or a device that failed.
- Breakers that keep trippingA breaker trips because of an overload, a short circuit or a ground fault. I find which one and fix that, instead of just resetting it.
- Flickering or dimming lightsFrom one bad bulb or dimmer to a loose connection that affects several rooms.
- Loss of power in part of the houseI check the panel, the breakers and the connections on the circuits that went out and tell you what I find.
- Buzzing, warm or scorched devicesOutlets, switches and fixtures that hum, feel warm or show burn marks are replaced, and the wiring behind them is checked.
- Fully insured
- Background checked
- 5.0 on Thumbtack · 54 reviews
- Electrician since 2020
Signs you need this
Some electrical problems are only an annoyance. These are worth a call.
- A breaker trips again right after you reset it.
- An outlet or switch plate feels warm, looks discolored or smells like something burning.
- Lights flicker or dim when a large appliance starts.
- Several outlets stopped working at the same time.
- You feel a tingle when you touch an appliance or a metal fixture.
How I work
- Step 1You tell me what is happeningCall, text or send the form. A photo of the panel or the outlet and a note on when the problem shows up help a lot.
- Step 2I test and find the causeI check the circuit with a meter, open the devices involved and follow the wiring until I find the fault.
- Step 3I explain, then repairYou hear what I found and what the repair involves before I start. When I finish, I test the circuit and leave the area clean.
Common questions
Is it safe to keep resetting a breaker that trips?
No. A breaker that trips again is telling you something is wrong on that circuit. Resetting it again and again puts stress on the breaker and on the wiring. Leave it off and have the circuit checked.
Why did several outlets stop working at once?
Often one GFCI outlet protects other outlets after it, in a bathroom, a kitchen, a garage or outside. When it trips, all of them lose power. Press its reset button. If that does not bring them back, or it trips again, the circuit needs a look.
What should I do before you arrive?
Turn off the breaker for that circuit if you know which one it is, unplug what was connected, and do not use an outlet or switch that feels warm or smells burnt.
Can you tell me the cost before you start?
Yes. Finding the cause comes first, because the repair depends on it. Once I know what is wrong, I tell you what the repair involves and what it costs before I do it.
Related services
See all servicesHave a job in mind?
Send a message with a few photos and get a clear estimate.